Area of Applications

Suitable for flooring and wall installations in both internal and external areas.

• Apply on flooring and walls for internal & external floor area applications.
• Can be used up to a maximum 12mm bed thickness.
• The joint width shall be as per the recommendation of the architect / engineer.
• Remove the spacers when the adhesive is set firm.
• Always use grout (Normal & Epoxy Grout) between joint width tiles / stones.

Precautions

Important safety and usage guidelines to ensure durability and long-term performance of the installation.

• Do not use for fixing artificial, nano, engineered stone, composites, or metal tiles.
• Adhesives for ceramic tiles, bricks, and stone are not designed as replacements for waterproof coatings.
• Do not apply directly on gypsum plaster, cement boards, plywood, chipboard, laminates, or deformable surfaces.
• Avoid using on metal, plastic, or vibration-prone areas.
• Never add sand or cement at site.
• Do not add excess water beyond the recommended limit.
• Protect the surface from direct rainfall and foot traffic for at least 24 hours after application.
• Keep out of reach of children. Use protective gloves, clothing, and eye/face protection.
• In case of skin contact, wash immediately with plenty of clean water.
• If contact occurs with eyes, rinse immediately with clean water and seek medical advice.

Application Instructions

Ensure the substrate and surface preparation are done properly to achieve optimum bonding and long-term durability.

• All surfaces should be between 40°F (4°C) and 104°F (40°C), structurally sound, clean, and free of dirt, oil, grease, loose paint, laitance, sealers, or curing compounds.
• The substrate must be level, cured, undamaged, compact, rigid, resistant, dry, and free from any debonding agents or rising damp.
• New concrete slabs should be damp cured and at least 28 days old before tile installation to reduce shrinkage.
• No minimum cure time is required for concrete slabs when thin-set mortar is mixed with a latex additive.
• Provide expansion joints throughout the tile work from all construction or substrate expansion joints.
• Do not cover or fill expansion joints with thin-set mortar.

How to Mix

• Use approximately 5 - 5.5 L of water for a 20 kg bag of powder.
• Before applying, place clean, potable water into a clean mixing bowl.
• Adjust the water as per desired consistency.
• No further water should be added once mixed.
• Leave the mixture to rest for 5 minutes before use.
• Allow the mixed adhesive to polymerize for 2–5 minutes and then mix again for 30 seconds.